Jared George traded in his Mercedes-AMG GT for a used but barely-driven 2024 Corvette Z06 with just over 3,000 miles on the clock. Less than a week later, he took it to a Texas dealership for its first oil change. He drove home, noticed an oil drip on his garage floor, and brought it straight back. While the staff was trying to place the car on a lift to diagnose the leak, it slipped. Photos shared to a Corvette owner's Facebook group show the Arctic White Z06 tilted at a steep angle on a two-post lift, its rear end angled toward the floor while the body leaned heavily to one side. With damage extending past the visual of broken fiberglass panels and gouges in the chassis, this $110,000+ Corvette Z06 is likely written off, thanks to a routine workshop visit.

View the 2 images of this gallery on the original article

The Wrong Tool for the Job

A two-post lift was the wrong call here. With the C8's mid-engine layout pushing roughly 60 percent of the weight over the rear axle, placing it on a two-post lift demands precise positioning and specific lift pad adapters. Get it even slightly wrong, and the physics are unforgiving. Four-post ramp lifts are far more forgiving for this kind of weight distribution, since the car simply drives onto the ramps and sits there stably. Several C8s have already fallen off lifts because of the heavily weighted rear, and yet two-post setups remain the default in most service bays. The C8 also has frame cutouts that an inexperienced technician might mistakenly identify as jacking points when they are actually tie-down slots used during transport. That confusion, combined with a rear-heavy platform most GM techs have never worked on before, is a disaster waiting to happen.

View the 2 images of this gallery on the original article

A Pattern That Keeps Repeating

In 2020, a red C8 Stingray fell off a lift after being improperly jacked up, and a blue Corvette suffered the same fate a year later in 2021. Then, in September 2023, a red Z06 slipped during a pre-delivery inspection. Now this. Four incidents (that we know of) in five years involving the same platform and the same failure. Enthusiast forums have been warning about this since the C8 launched.

The fix isn't complicated. Jacking pucks that clip into the correct frame slots make the lift points immediately obvious, and several forum veterans recommend leaving them on the car permanently so any technician can see exactly where to go. Some owners have even suggested GM should mark the spots with high-visibility indicators from the factory. The C8 is not a difficult car to lift safely. It just requires a technician who actually knows what they're doing, and dealerships, it seems, haven't gotten that message yet.

Another Corvette Falls Off a Dealer Lift—Is This Becoming a Pattern?