Brians Questions:

Hello and greetings from Texas,
I’m an amateur woodworker who may have bitten off a little more than I could chew. I started building full closet cabinets for my walk-in master closet, and at this point I’m too far in to turn back, so I’m learning as I go.
All of the cabinet boxes are installed, and I’m now working on shelves and drawer fronts. My question is about face frames. I’ve seen a lot of people recommend assembling the full face frame first and then installing it as a unit, rather than attaching each rail and stile individually.
What are the real advantages of building and installing the face frame as one piece versus installing it piece by piece?
One complication in my situation is that my walls weren’t perfectly square when I started, and as a result some of my cabinets aren’t perfectly square either. I’m trying to figure out which approach will give me the best final result given those imperfections.
Thanks for taking the time to read this, and for all the knowledge you put out there—it’s been a huge help on this project.
Thank you,
Casey
Wood You Rather

1. The first question is about accuracy. What is your own degree of tolerance when it comes to measurements, without going crazy? I guess it depends on the project, but for example, when cutting panels to specific dimensions with a track saw, do you try to get the measurements down to the nearest 1/16th? nearest 1/32nd? 1/64th?
2. On a related note, the measuring marks on the ruler or parallel guides of course have a width themselves… Do you place your pencil or stop pointer just before the line/mark, in the middle of the line, or just after the line? Does it not matter as long as you’re consistent? I know this isn’t NASA, but I don’t want the project to ultimately look amateurish. Josh

Guys Questions:

First, thank you for answering my other questions.
Guy points out that Rubio Monocoat is made for wood floors when others talk about using it on wood furniture. Is there an actual disadvantage or problem with using Rubio on fine furniture when you want a finish that can withstand the abuse that a floor gets?
Thanks again for the great show!
George

3. Any advice for staining blotchy baltic birch plywood with Gel stain and tips for finishing with water-based urethane topcoat? I have heard so many different opinions, from putting a slip coat of mineral spirits, to using preconditioner, to applying gel stain directly on the wood, etc. Josh

Huys Questions:

I am working on a large kitchen cabinet project and have come across a few questions I thought would make good discussion. Project includes 16 base cabinets, 14 uppers, range hood and a couple of custom spice racks, open shelves etc. Upper will have 14" upper uppers stacked on them with glass fronts. Lowers are almost entirely drawers. Carcasses are about done heading into face frames and drawers.
-Ripping down face frame lumber. When batching out large amounts of 1 1/2" strips what is your preferred method. Table saw then sand? Table saw proud then plane? Table saw then drum sand? Will a bandsaw with ripping blade provide a nicer edge? Major concerns are efficiency and accuracy while avoiding saw marks that have to be hand sanded off.
-Ever use a shaper to add dado on 8' strips of wood for drawer box parts? Wondering if there is a good way to setup the shaper with power feeder to run through all the strips then cut to length. Essentially making my own drawer blanks.
Any other thoughts or recommendations when batching out large cabinet projects.
Matt

I have the Grizzly benchtop oscillating edge and spindle sander that I believe a couple of you have mentioned owning currently or in the past. I’m working on some oak glue-ups that are using some odd angles that will be template routed later. The problem I’m having is that when I use the edge sander to dial in these pieces my edges are getting slightly rounded over and becoming convex. I’d love to have a large disk sander but this is what I’m working with and I can’t figure out if it’s a tension or pressure issue or the oscillation is causing it… any help is greatly appreciated! Keep up the great work! Shawn